tx216 v3:QSPIFLASH.
d:3 c:3
bv:TX510(qflash)_V0R37
4dd:41000 5dt:232000 5dd:292000
a
b
c
board init!
alios start
qflash init ok.
kv_init
========================================
Software Version: V0.0.7
Build Date: Feb  6 2023, 18:38:59
========================================
Version: TX510(804)_T2_V1R021C011
kv_init
Face recognition enable: false
Failed to load expo init mode of sensor -2
get exp value=0.000000
uvc preview mode is 0
get aieresult_print failed
get run mode cover failed
move data end
isp_init, isp_id: 1, mode: 2
set mipi_config, raw10, 1lane.
Check T8820 ID:
CHIP ID: 22 50 00 00 00
CHIP VERSION: 02
isp_config, isp_id:1, in->format:4, in->res:10, out->format:0, out->res:3
cfg_isp_raw_bypass, MI_CTRL: 0x6A3A4B02
cfg_isp_raw_bypass end. isp_id:1
T8820 config enter 1600x1200, RAW10, MONO, VERSION_D
isp_init, isp_id: 0, mode: 2
set mipi_config, raw10, 1lane.
Check T8820 ID:
CHIP ID: 22 50 00 00 00
CHIP VERSION: 03
isp_config, isp_id:0, in->format:4, in->res:10, out->format:0, out->res:3
cfg_isp_raw_bypass, MI_CTRL: 0x6A3A4B02
cfg_isp_raw_bypass end. isp_id:0
T8820 config enter 1600x1200, RAW10, MONO, VERSION_D
Check T8820 LED Device ID:
DEVICE_ID 01
Set LED #1 mode 2 to current 200 (value: 0x10)
Set LED #2 mode 2 to current 15 (value: 0x0)
Set LED #1 mode 1 to current 200 (value: 0x43)
Set LED #2 mode 1 to current 15 (value: 0x2)
tx dphy clk in 500, clk selectc 500, hsfreq 0x26
mipi lcd 5.5 inch hx8394f init success.
Failed to allocate memory. if_vInitial 4185
uart ready
wait dma
w ok
check_flash_data_move_done:153 enter,dma_cb_flag:0x1
living3DThres      = 0.001000
livingNirThres     = 0.660000
faceMatchThres     = 0.000000
faceMatchMaskThres = 0.120000
aie init
Get ff first boot is 1
load ff
do check weight.
config es8311 codec
weight check  ok